Electric Foam Wire Knife (The Army Painter)

This incredibly precise Hot Wire Foam Cutter will provide you with clean, accurate, and fast cuts - every time! It is the perfect tool for cutting XPS foam sheets for any dungeon backdrop, wargaming terrain, or landscape. The set includes 4 additional wires.

• No more messy foam cutting - the Hot Wire Foam Cutter slices through Styrofoam and XPS foam with precision and ease.
• Easy one-handed operation - Simply press the thumb activation button and start cutting the Styrofoam sheet.
• Minimal waste on the foam board - The thin 0.19 mm heated wire allows for very fine details.
• Precautions - The hot wire foam cutter can reach 300℃/572℉, making cutting easy.

Note: Batteries are NOT included (2x C batteries).

- Hold the activation button to quickly heat the wire to 300°.

- Slow movement allows for precise cutting and protects the wire.

- Maximum cutting size: 4 cm × 12 cm

How to use

1. Hold the activation button to quickly heat the wire to 300°.
2. Move slowly to achieve precise cuts - and protect the wire.
3. Maximum cutting size: 4 cm x 12 cm
4. Use in a well-ventilated area.

Wire replacement
The set includes 4 additional wires, to replace the wire:

1. Remove the batteries.
2. Take out all old wire parts.
3. Insert the end of the new wire and twist the end to hold it in place.
4. Repeat the steps on both ends.
5. Insert the batteries and you are ready to go.

Safety instructions

• Remove the battery when not in use.
• Do not touch the heating wire. Remove the battery when replacing the heating wire.
• Do not place near flammable materials. Use only specially designated heating wire - do not install other metal materials.
• Do not use in humidity greater than or equal to 85%. Children should use this tool only under adult supervision. Store in a place inaccessible to children.